No products
Product added to your shopping cart
There are 0 items in your cart. There is 1 item in your cart.
Pulleys/Sheaves
- Electronics
- Battery
- Buzzers
- Cable
- Capacitors
- Circuit Boards
- Circuit Breakers
- Coils/Inductors
- Connectors
- Cord, Power
- Counters
- Crystals
- Digital ICs
- Diodes
- Enclosures
- Fans/Blowers
- Filters
- Fluorescent
- Fuse
- Grounding
- Hardware
- Heat Sinks
- Heating Elements
- Inductor
- Instruments
- Lamps/Sources
- Meters
- Miscellaneous
- Motors
- Optoelectronics
- Panels
- Plugs/Outlets
- Potentiometers
- Power Supply
- Products
- Rectifiers
- Regulators
- Relays
- Resistors
- Sensors
- Solenoids
- Speakers
- Suppressors
- Surge Arresters
- Switches
- Tape
- Testers
- Thermocouples
- Thermostats
- Timers
- Transformers
- Transistors
- Trimmers
- Tubes Electronic
- Wire
- Hardware
- Anchors
- Bearings
- Belts
- Bolts
- Braces
- Bumpers
- Bushings
- Catches
- Chain
- Clamps
- Collars
- Dampner
- Door Bells
- Door Stops
- Dowels
- Fittings
- Gears
- Handles
- Handrails
- Hasps
- Hinges
- Hooks
- Hose Clamps
- Knobs
- Latches
- Leveler
- Lever
- Locks
- Magnifying Glass
- Mounting
- Nails
- Nuts
- O-Rings
- Pipe Support
- Pulleys/Sheaves
- Pulls
- Rivet
- Rollers
- Screws
- Shafts
- Shelving
- Slides
- Springs
- Sprockets
- Standoffs/Spacers
- Staples
- Straps
- Strike Plates
- Strut System
- Tacks
- U-Bolts
- Upholstery
- Valves/Fittings
- Wall Hangers
- Wall Plates
- Washers
- Industrial Items
- Odds & Ends
- Office Items
- Photo, Film, A/V
- Tools
Information
For convenience,
products are pictured
on a 1" x 1" grid.
There are 100 products.Pulleys/Sheaves
1-Inch Pulley, Double Sheave, CopperTools #765-5212CopperToolsOLD BUT SEALED, ORIGINAL PACKAGING, acquired through a liquidation sale.Listing is for one (1) each 1-inch pulley, double sheave, CopperTools #765-5212, for 1/4-inch rope diameter, fastened round eye, nickel plated with brass sheave, ideal for awnings, hanging plants, boat rigging, window blinds, flagpoles, rust resistant, comes exactly as shown in the...
$3.791 in stock$3.79
USED V-Belt Pulley, 2.000" O.D.Used V-Belt Pulley; 2.000" (2") outside diameter, 1-Setscrew ; 0.500" (1/2") hole size. Accepts: 0.375" (3/8") bottom belt width, 0.500" (1/2") top belt width, 0.313" (5/16") belt thickness.
$2.001 in stock$2.00
USED Timing Pulley 3/8" Pitch 9 Teeth 5/8" BoreUSED, salvaged from school surplus equipment, no spec sheet, all measurements approximate.Listing is for one (1) each timing pulley, synchronous, uses 3/8" width belt, comes exactly as shown in the photo.PITCH: 3/8"TEETH: 9BORE (Hole Size): 5/8"SET SCREW: uses 3/4" x 0.095" expansion pin (not included)KEYWAY: n/aHUB (OD): 5/8"LTB (Length Through Bore):...
$2.861 in stock$2.86
USED V-Belt Sheave Idler, 0.868" O.D.Used V-Belt Sheave Idler with Ball Bearings ; 0.868" outside diameter (0.743" groove diameter) ; 0.122" hole size ; 0.156" width.
$1.471 in stock$1.47
USED Gear Ratio Control, Type 1-1/2ATUAbart Gear & Machine Co.Used Gear Ratio Control, Product Markings: Type 1-1/2ATU, Rated .500HP, Input Speed 1750, Rato 9-2/3 to 1 .
$68.00Out of stock$68.00
3/4-Inch Pulley, Double Sheave, CopperTools #765-5202CopperToolsOLD BUT SEALED, ORIGINAL PACKAGING, acquired through a liquidation sale.Listing is for one (1) each 3/4-inch pulley, double sheave, CopperTools #765-5202, for 3/16-inch rope diameter, fastened round eye, nickel plated with brass sheave, ideal for awnings, hanging plants, boat rigging, window blinds, flagpoles, rust resistant, comes exactly as shown in...
$3.791 in stock$3.79
USED Flat Belt Sheave Idler, 0.983" O.D.Used Flat Belt Idler with Ball Bearing ; 0.983" outside diameter ; 0.237" hole size ; 0.316" width .
$1.581 in stock$1.58
USED Flat Belt Pulley, 1.125" O.D.Used Flat Belt Pulley ; 1.125" outside diameter (0.870" groove diameter) ; 0.505" off-center hole size ; 0.505" width .
$1.351 in stock$1.35
USED Flat Belt Sheave, 5/8" O.D.Used Flat Belt Sheave ; 5/8" outside diameter ; 0.206" hole size ; 0.346" width .
$0.632 in stock$0.63
USED Grooved Sheave Idler, 0.996" O.D.Used Grooved Sheave Idler with Ball Bearings ; 0.996" outside diameter ; 0.151 bolt diameter ; 0.157" width; 0.547" total bolt length; Threads: #6-32tpi .
$1.591 in stock$1.59
USED Grooved Pulley, 1.500" O.D.Used Grooved Pulley ; 1.500" outside diameter (1.325" groove diameter) ; 0.379" hole size ; 0.400" overall width (0.225" sheave width) .
$1.601 in stock$1.60
USED V-Belt Sheave, 0.532" O.D.Used V-Belt Sheave ; 0.532" outside diameter (0.448" groove diameter) ; 0.059" hole size ; 0.218" width .
$0.633 in stock$0.63
USED Grooved Sheave Idler, 0.797" O.D.Used Grooved Sheave Idler with Ball Bearings ; 0.797" outside diameter ; 0.157" width; 0.537" total bolt length; Threads: #6-32tpi .
$1.392 in stock$1.39
USED Grooved & Flat Belt Pulley, 0.755" O.D.Used Grooved & Flat Belt Pulley ; 0.755" outside diameter (0.686" groove diameters) ; 0.197" hole size ; 0.782" overall width (0.380" flat belt width; 0.075" groove width) .
$1.252 in stock$1.25
USED Flat Belt Sheave, 0.646" O.D.Used Flat Belt Sheave ; 0.646" outside diameter (0.567" groove diameter) ; 0.162" hole size ; 0.192" width.
$0.741 in stock$0.74
Filters
