No products
For convenience,
products are pictured
on a 1" x 1" grid.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement, begins to step at about 3VDC- 5VDC.Listing is for one (1) Warner Electric Brake & Clutch SM-024-0035-WT, no instruction manual, comes exactly as shown in the photo.• 5.0 Ohm• 1.5 Amp• Impedance Protected• 1/4" Diameter Shaft• 3 Optical Wires & 4 Clutch/Brake...
USED, salvaged from school surplus equipment, no data sheet.Listing is for one (1) each dc motor, Matsushita MAX-13VILB, no instruction manual, comes exactly as shown in the photo.• 8VDC• 1/8" Diameter Shaft, 0.264" Diameter Pulley (Approximate)• 4 Wires (Blue/Red White/Yellow)
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement, shaft starts to rotate at about 2VDC, demonstrates good shaft rotation at about 6VDC.Listing is for one (1) each dc motor T25671 50527B, no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment, no data sheet, made in USA.Listing is for one (1) each ac servo motor, Diehl Cat. No. FPE21L-165-1, no instruction manual, comes exactly as shown in the photo.• Volts: 115V • Cycle: 60Hz• Phase: 2• Output Watts: 3• Poles: 2• Duty: Cont.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement although begins to activate/step at about 3-5VDC minimum.Listing is for one (1) each dc motor, Nidec 27F5094005, product markings include P/N 20256-001J1, 4mm diameter shaft (approximate), no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement although demonstrates good shaft rotation at about 5VDC-9VDC.Listing is for one (1) each dc motor, Sharp LLA6B01, no instruction manual, comes exactly as shown in the photo.
USED TF200B05 Motor, acquired through school surplus, no data sheet, begins to rotate at 1VDC, runs nicely under load at 12VDC, contains four wires (yellow/green pair at .534 k-ohm, red/blue pair at 34.6 ohm), runs clockwise (Blue+/Red-), runs counterclockwise (Blue-/Red+), windings test good using a megohmmeter tester, shaft requires a 5mm width belt...
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement, demonstrates good shaft rotation at about 9VDC.Listing is for one (1) each dc motor, product markings include D-011G SF600R01 20118-H, no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement, demonstrates good shaft rotation at about 5VDC, generates about 2.5VAC via purple wires at 5VDC.Listing is for one (1) each dc motor, Sony DNF-1000A, product markings include 26100E, no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment (removed from old VCR), chipped circuit board (see photo), no spec sheet, unknown voltage requirement, demonstrates good shaft rotation at about 5VDC to 9VDCListing is for one (1) each dc motor Mabuchi PU60628-3-1, no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement, demonstrates good shaft rotation at about 9VDC.Listing is for one (1) each dc motor MCA9B, product markings include 5-557736 40724-A, circuit board# YG-437F, no instruction manual, comes exactly as shown in the photo.
USED, salvaged from school surplus equipment, no data sheet, unknown voltage requirement although shaft begins to rotate at about 3VDC, demonstrates good shaft rotation at about 9VDC.Listing is for one (1) each dc motor, Orion MCB2B01, product markings include 50302-A, no instruction manual, comes exactly as shown in the photo.
Filters